Operation 12V DC Regulated Power Supply

BySAWH'S

Operation:

  1. Insert AC power plug into 110 volt AC outlet.
  2. Connect the power cord of your equipment with proper input voltage to the output binding post terminals on the front  of the unit. Be sure that polarity is correct. The RED positive (+) terminal and BLACK negative (-) terminal are marked, reversal of polarity may damage your equipment.
  3. Turn switch to “ON”, the light in switch should be turned on or illuminate.
  4. The input power is protected by the fuse which is located at the rear of the unit and can be replaced by unscrewing the fuse holder if the fuse is burnt out, please use the same rated fuse for replace.
  5. This unit has ‘short-circuit protection’ with automatic reset function.

Caution:

  1. DO NOT USE with equipment requiring more than rated amps.
  2. DO NOT USE outdoor, do not expose unit to rain, moisture, water or any other liquids.
  3. DO NOT REMOVE cover, return to dealer for repair if damaged.
  4. When the unit is used on full load for a long term, be sure that its ventilation and heat-sink are good. 

Similar Posts

  • CR2 vs CR123 Battery

    BySAWH'S

    Comparing the differences and similarities between CR2 and CR123 batteries. We are going to answer these two questions: Is the CR2 battery the same as CR123? Can CR2 and CR123 batteries use interchangeably? The image below clearly shows the difference between CR2 and CR123 batteries. While CR123 battery and CR2 battery have the same voltage…

  • Car Audio Amplifier Function/ Installation Guide

    BySAWH'S

    Speaker connection – Never connect cables with the chassis ground. This may destroy your amplifier. Check that your speakers are connected correctly which means plus (+) to plus (+) and minus (-) to minus (-). Recommended speaker cable from 2.25mm to up.  BATT+ – Battery + terminal. The +12 Volt power cable must be connected with a…

  • Safety Precautions when using a Pressure Cooker

    BySAWH'S

    The following are Important Safeguards / Precautions that are recommended by most appliance manufacturers.  Important Safeguards (Safety First (1st):   To reduce the risk of personal injury or property damage, basic safety precautions should always be followed, including the following:  Always check the exhaust pipe before use. Hold cover up to light and look through…

  • Optimizing your Wi-Fi Network as Fast As Possible – WiFi Tips and Tricks

    BySAWH'S

    Tips on how you can improve your WiFi performs at your home. Position your access point correctly Position your access point usually your router correctly, the coverage area is spherical in shape. So center your access point within your intended coverage area as best as you can. Then it comes down to signal strength. It comes…